Hand-tight

Headphones on the desk take up the space you work in. Headphones under the desk are out of reach. The desk edge is the one place that is neither.

Three moves

1. 

   1 · Slide it on

   Open the clamp and slide it onto a solid desk edge.

2. 

   2 · Turn the screw

   Turn the screw under the desk until the clamp holds firmly. Hand-tight is enough.

3. 

   3 · Hang them

   Rest the headband across the hook, and check the clamp stays put.

Why a clamp

Using the desk edge frees the work surface without putting the headphones out of reach. The threaded clamp does the holding, so there is no adhesive to loosen or leave residue, and taking it off is the same three moves in reverse.

Will it fit your desk?

The jaw is made very deep, so it fits practically any desk thickness. Before you order, measure the thickness of the desk edge and the unobstructed depth below it, where the clamp screw will sit. The preview uses an illustrative 25 mm desk.

Building in a Corsair 5000D or 5000X? Five centimetres of space hangs the headset on the side of the case instead. Every step for this holder is also in its setup guide.