Most fit questions are answered in two minutes with a ruler. Tick through the section for the design you are looking at. (The ticks are just for you and stay on this device.)
GPU supports I measured straight down from a support point under the card to the PSU shroud or case floor. My gap fits a size: 50–70 mm, 70–130 mm (about 70 mm base-only), or 75–110 mm for the branded support. Adjustable (unbranded) support: a magnet sticks to the surface the base will stand on. The branded support has no magnet; it needs a flat, level spot. All checked. Open the matching designs: Adjustable GPU Support , Branded GPU Support
PCIe fan mounts I have enough free slots below the card: two for the 40 mm mounts, three for the 60 mm mounts, one mounting position for the 120 mm. My case profile matches: low-profile mounts for low-profile cases, the high-profile 60 mm for full-height openings. I checked fan thickness and the clearance beneath the GPU and around nearby cards and cables. I have the fans and fan screws (they are not included). All checked. Open the matching designs: Low-Profile 40 mm GPU Fan Mount , Dual 40 mm PCIe Fan Mount , Low-Profile 60 mm PCIe Fan Mount , High-Profile 60 mm PCIe Fan Mount , 120 mm PCIe Fan Mount
EliteDesk 800 Mini fan mount My EliteDesk 800 G-series Mini has the perforated (vented) lid. I have up to four 60 mm fans up to 25 mm thick, one 40 × 40 × 20 mm fan for the rear seat, and a layout in mind. All checked. Open the matching designs: EliteDesk 800 Mini Fan Mount
AIO combs and clips I know my tubing’s outside diameter, including its sleeve. I know the spacing between the two tubes where the comb will sit. All checked. Open the matching designs: AIO Radiator Comb & Clip , ASUS Red-Logo AIO Clip
Case and desk My case is a Corsair 5000D or 5000X (for the case headphone holder). I checked my phone with its case on (phone grip and stand). My watch’s charging puck matches the recess size on the listing (Apple Watch stand). All checked. Open the matching designs: Corsair 5000D / 5000X Headphone Holder , Pinky Saver Phone Grip , Minimal Smartphone Stand , Apple Watch Stand
Everyday carry My bottle-cage bosses are 65 mm apart, centre to centre, and I know which tracker I have (AirTag or FineTrack). I picked a slider size: Small 43 × 18 mm, Medium 55 × 25 mm or Large 70 × 35 mm. I chose one, two or three keys for the keychain. All checked. Open the matching designs: Bicycle Tracker Mount , Magnetic Fidget Slider , Clicky Fidget Keychain
Still unsure?
Ask with specifics: the case model, the graphics card or device, your measurement and where the part will sit. That beats asking whether something is universal. Contact us .
Every design’s page repeats its own fit checks.
Browse the designs 
